Terminating Component Editing

The CloseComponent command ends the in-place editing of a Block definition or Reference initiated by the EditComponent command.

To end in-place editing of a Block definition or Reference:

  1. Click Modify > Component > Close (or type CloseComponent at the command prompt).
  2. In the Component dialog box, click Save to save the changes of the Block definition or Reference you have edited

    - or -

    Click Discard to end Component editing without saving the changes.

  Use SaveComponent to save the changes and end the Component editing session.

Access

Command: CloseComponent

Menu: Modify > Component > Close

Related Topics

In-Place Editing of Blocks and References

Adding or Removing Entities During Component Editing

Modifying the Base Point of a Block Definition

Saving Component Edits