Inserting Blocks
You can insert a Block or drawing file into a drawing.
To insert Blocks:
- Click Insert > Block (or type InsertBlock).
- In the dialog box, in Name, select a Block, or click Browse to locate an external drawing.
- Under Position, for X, Y, and Z, type coordinate values, or select Specify later to specify the insertion point on screen after the dialog box closes.
- Under Scale:
- For X, Y, and Z, type the scale factor for each axis.
- or - - Click Specify later to define the Block size during insertion. Specify the Corner option, then define the opposite point of the rectangle where the Block is to fit.
- or - - Click Apply uniform scale, and for X, type a scale factor. A scale factor of:
- 1: Inserts the Block at its original size.
- Less than 1: Reduces the size to the percentage of the original size specified by the factor.
- Greater than 1: Increases the size.
- Under Rotate, for Angle, type a value or select Specify later to set the rotation angle in the graphics area during insertion. For counterclockwise rotation type a positive value, for clockwise rotation type a negative value.
- Under Block UnitSystem:
- You cannot edit the Units or Scale. If Scale is unequal to 1.0, then the drawing units differ from the Block units.
- Select Explode Block to explode the Block into its component entities. A Block loses its characteristics when exploded. You can explode uniform scaled Blocks only.
- Click OK.
Access
Command: InsertBlock
Menu: Insert > Block